Locking an Indicator to UserID in MC?

[daedalus 10]

In TS I would use:

 

If CustomerID = 123456 then begin
Plot1(Close,"Close");
End; 

 

When I use the same code to my CustomerID in MC (I put the code after my inputs and variables) it kills the indicator?

 

It still stays on the chart and says its on, but nothing appears. I comment out the code and it comes back.

 

Any ideas?

[Tams 20]

In TS I would use:

If CustomerID = 123456 then begin
Plot1(Close,"Close");
End; 

When I use the same code to my CustomerID in MC (I put the code after my inputs and variables) it kills the indicator?

It still stays on the chart and says its on, but nothing appears. I comment out the code and it comes back.

Any ideas?

 

 

I am not sure if I understand what you mean.

 

 

 

In your code... it is trying to do the following:

 

If the CONDITION is correct,

then DO this....

 

else {the following is assumed}

 

If the CONDITION is incorrect,

DON't DO ANYTHING

 

Is this what you had in mind?

[daedalus 10]

Yea, thats what i'm trying to do... IE if the customerid matches the one in the code, make the indicator work, else, don't work. Trying to stop redistribution of indicators in the future.

[Tams 20]

change

 

CustomerID

 

to

 

GETUSERID

[daedalus 10]

You are freaking brilliant.

 

If you're ever in Omaha i'm buying you dinner.

[Tams 20]

You are freaking brilliant.

If you're ever in Omaha i'm buying you dinner.

 

 

If I hop on the plane now, I think I can make it to dinner for tomorrow night.

 

;-)

[Tams 20]

you can add more securities/limitations into the code:

 

 

e.g.

 

Password

 

input:

Password(12345);

 

If password = 12345 then

begin

 

 

Time Limit

 

If computerdatetime < 1081231 then

begin

 

 

1081231 equals to 2009 December 31

 

i.e. the code will expire and stop working after December 31, 2009.

Edited June 29, 2009 by Tams